One of the most frustrating automobile breakdowns is a completely fired engine. Replacing your car’s engine is a major operation. Hence, whether the damage was caused by bad luck, lousy manufacturing or your bad maintenance habits, it is crucial that you find out how much replacing the engine will cost you. One of the most common questions from car owners is how much an engine replacement costs. However, it is tough to give an actual value until a professional mechanic takes the time to evaluate the car in garage door repair chicago . Engine replacement cost can vary widely, depending on the application, the donor engine and who does the work.
If you have a Japanese car, you can opt for a frequently used low mileage engine imported from Japan. Using these engines is usually the most economical and reasonable way to go, with most of them being done for around $2000.
For a European luxury car, the cost of engine replacement usually exceeds the value of the vehicle. Hence, scraping the car is, unfortunately, the best option from a financial point of view. For a standard American car, it is highly recommended to locate a suitable, low-mileage engine at a junkyard and have an independent mechanic do the installation.
The cost of engine replacement depends on many factors, including the following:
• Size and type of engine: some engines can cost around $1000 or $2000 to replace whereas the high-performance ones can go for about $9000.
• Is the engine replacement going to be new, used, remanufactured or rebuilt?
• What are other external parts such as hose, water pump, and other parts going to need replacement?
• Do the electronic and computerized elements need replacement?
All of these components are usually included in the final quote to come up with an accurate engine replacement cost.
Other causes for extra costs:
• Broken parts: As a car age, it is highly likely that rust will cause corrosion on many parts, including bolts which increases the risk of pieces breaking. Replacing broken parts adds to the cost of engine replacement.
• Regular maintenance is not up to date: If your engine’s regular maintenance is not up to date, you should expect some extra costs.
Features to consider when determining the cost of engine replacement
There are a lot of factors you need to take into consideration when you are looking at engine replacement and the costs involved. Here are the most common ones:
1. Do you need a long-block, short-block or a new complete engine?
2. What type of engine and make are you looking for and where are you planning to source it from? For instance, a brand new engine sourced directly from a Mercedes Benz warehouse is clearly going to cost you a tooth and an arm compared to getting a remanufactured or a junkyard engine.
3. Age: Generally, engine replacement cost for domestic or Japanese vehicles keep getting expensive as new models continue to be invented. For example, newer European engine replacements are always relatively expensive, hard to come by and even more difficult to get a used one at any age.
4. The other thing you need to take into consideration when calculating your engine replacement cost is where you are getting it done and how fast you need the replacement done
Basic Engine Costs
A complete engine should have all the essentials it needs to run, including every accessory, electronic component, and sensor. Such kind of replacement is usually rare under warranty.
A long-block engine is a whole engine minus accessories, electrical equipment, and manifolds. Most engine replacements only include the long block. A long block engine can be installed quickly, efficiently and makes a suitable replacement for any engine that has been written off.
A short-block, on the other hand, is a long block without the cylinder head. It is designed for cases where the full engine does not need to be replaced, but just parts of it. Hence, it is much cheaper compared to a long-block engine.
The cost of a typical American or Japanese four-cylinder long-block engine cost anywhere between $1,500 to $2,000 when purchased from a renown engine remanufacturer. The short-blocks usually go for approximately $600 to $800 less. The cost of complete “bolt-in” engine costs twice as much as the long-block. However, you can cut costs, often by half if you buy a junkyard engine. Still, there is no guarantee that it is in a better condition compared to the one you have taken out.
Most times, labor can cost you just as much or slightly lower than the engine itself. This is especially true if you go to a specialist or a dealer. Your local garage may charge anywhere from $50 to $75 an hour whereas a dealer or specialist will easily quadruple that amount. Typically, an engine replacement lasts from 10 to 15 hours for an old car model and 15 to 20 hours on a new automobile. Also, a good quota of that time is spent on the amount of work the shop needs to do to transfer the old parts to the new engine block. This is usually where you could lose money by choosing to buy a short block or long block engine. At times, it is better to spend a little more money up front, especially if the mechanic’s hourly rate is expensive.
On average, expect to pay $1000 in labor for a complete engine replacement from your local garage or $7000plus, if you opt to use a specialist to take down your old engine, put together the new one, and install it.
So what is the total cost of an engine replacement?
From the outline above, it is pretty clear how engine replacement cost can vary, even on the same vehicle. For instance, a DIY engine replacement may cost as little as $1,000 if you do all the work on your own. It could also cost you up to $7000 if you buy a complete engine and pay a dealer or a specialist to install it. Take the time to shop around and compare labor rates and agreements before opting to use the services of a specialist.