Sm465 for sale on US's largest classifieds sites (97 results)
I have for sale a 1985 K20 (3/4 ton) Chevy Silverado. 350, 4 spd manual (SM465), 205 transfer case. Runs, drives and stops fine. I can jump in, turn the key and go with no problems. Fun truck to drive with the manual trans! The truck is geared low, I assume it's 4:10 gears. Typical rocker rust, floor
Truck has brand new tires, Sm465 trans granny low. Full floater rear. No Ac manual Windows. Truck is in good shape rust is surface and alittle bit in floor had rubber floor I removed. Solid old truck, not perfect but heavy duty dependable rig. Truck is tagged And driven. 106000 miles on body motor
Year: 1984, Make: Chevrolet
Have a turn key monster wheeler that routinely tackles very tough trails and just needs cleaning at the end of the day so if you're not into driving like an old lady (sorry old ladies)replacing axles,hubs,ring and pinions etc or pulling winch line all day just because it rained then this could be exac...
Selling my 1988 k5 blazer. I bought this truck last year and haven't had a single problem. The truck runs good and sounds great! The guy I bought it from says that he rebuilt the engine which has 10000 miles on it but I wasn't given any paper work that confirms this. This blazer has a 4 inch lift, cus...
I am selling my 1986 Chevrolet C30 Dually with a flatbed. The person i bought it from used it to haul lumber and i guess wasnt a good driver so the bed is dented. Simple enough fix or leave as is. Bought in Burlington last year and drove to Smithfield without the slightest issues.(other than A.C Not w...
I have 2 square body trucks for sale. Both of the bodies are in rough shape but are good for the axles and drivetrain. Both trucks are 70s and have been on my property for years.1st truck is a single cab stepside and has a 350, sm465 manual and a 203 or 205 transfer case. Truck is a half ton a
PLEASE READ FULL AD!!!A 77 c30 3+3 dually project.Cab is in great shape, bed has some rust.Was an automatic, currently has a mechanical clutch setup in it. I plan to leave the c-code 6.2l with new glow plugs, gaskets, and seals. And the Muncie SM465, that I put behind it, with
Year: 1977, Make: Chevrolet
1971 chevy k20 pickup. 3/4 ton, 4wd, converted to a short bed stepside. 350 engine, ceramic coated headers, edelbrock air gap manifold, 600 cfm carb. Flowmaster super 44 exhaust, newer tires, nice interior, 14 bolt rear. Not sure of ratio. Sm465 manual trans, new tires. Registered as a collector vehi
Complete Chevy 3/4 4x4 with a flatbed. Body is pretty well shot frame has been beefed up in a few areas. It has a great drive train which is why I bought it originally but things change and I am not going to use it. Very good running chevy 350 4 bolt main with a sm465 Trans bolted to a np205 tcase. 14
1984 K20; 4X4 3/4 Ton Chevy Pickup; 8' bed; 3" body lift; 33" tires; Recently built 400ci Small Block Chevy engine with Comp Cam and Vortec Heads; Aluminum intake and Holley 750 carb; Brand new full length dual exhaust with Brand new Hooker Headers; 4 speed manual transmission (Muncy SM465); New Proce
I have a 1991 chevy C2500 that I would like to sell our trade. Or....... I am also wanting to convert this truck to carb (qjet) and hei with a nv4500, so if you have that for sale please call me! Truck has 217k miles and is going up. It is my understanding (and the evidence is convincing)
1986 Chevy 1/2 with loadtrail flatbed. The frame and driveline are from a mid 70's 1 ton Chevy. It has a sm465 that pops out of 3rd gear. I use it to haul my firewood with. Has either a 305 or a 350 with edelbrock 4 barrel and headers. New clutch less then 250 miles ago. Has gooseneck hitch and some o
Great all around Truck! Good on the trail, pulls well, and it will keep up with traffic. Only 17,000 miles on the truck since last frame off restoration. To many upgrades and extras to remember but here are some highlights!GM Performance Parts RAMJET 350 engine (port fuel injection, Vortec
Year: 1967, Make: Chevrolet